prefect
Home Engineering Publications
DACS: Power
 
  next up previous contents
Next: Mixer Unit Up: Control Board Previous: Control Board   Contents

Power

The control board is primarily a digital device, and as such does not require any negative DC voltages. The primary supply voltage is +5V, thus greatly simplifying both the power supply and power distribution methodology. Figure 27 shows the pinouts for the connector used to distribute power to each of the PC boards inside of the control board.

Figure 27: 4 circuit 0.156in spaced connector, used for power distribution in the control board.
\begin{figure}
\psfig{file=fig/156-4pin.eps}
\vspace{0.25in}
\begin{tabul...
...hline
3 & GND \\
\hline
4 & +5V \\
\hline
\end{tabular}
\end{figure}

There shall be 10$\mu$F of power supply bypass capacitance for each supply line used on each PC board. Additional 0.1$\mu$F bypass capacitors shall be placed near each IC, as appropriate.

Steve Richardson 2000-07-06
Table of Contents

[PDF] [Whole document in PDF 1.9MB]

[more photos and information]

 
Page last modified:
Copyright © 1993-2000 prefect - All Rights Reserved.